26 Ağustos 2015 Çarşamba

Automate Viewpoints for Rooms in Navisworks

It is a general requirement especially for Facility Management to create Navisworks Viewpoints of each Room defined in Revit. Find below the Dynamo flow, you can use this to create 3D Views of each room and you will have the Viewpoints ready for each Room.

I used the Room numbers for the Viewpoint Names which you can change to be Room Name or any other information. Also I used 1,75 meters for the Eye and Target Elevation which you can also change.

Run the Dynamo after you defined the Rooms in Revit and 3D views will be ready. If you change any room data (name, number or size) run the Dynamo again for update. When you open the Revit file in Navisworks your Viewpoints will be ready.

The sample is done for Rooms in Revit and you can use this for doors, valves, equipment and etc. as you may require.  We used this process for 3.000 Rooms and all Viewpoints were ready in less than 30 minutes in Navisworks.


Hope this simple process will help to save your valuable time….


ProCS_Room Viewpoints_2015

Hiç yorum yok:

Yorum Gönder